Seiko Group UB-R02 Manual de usuario

Busca en linea o descarga Manual de usuario para Componentes del interruptor de red Seiko Group UB-R02. Seiko Group UB-R02 User's Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 4
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
1
UB-R02 User’s Manual
Copyright © Seiko Epson Corporation 2004
Printed in China 2004.01
Introduction
The UB-R02 is an interface board on which is installed an IEEE 802.11b Radio
Frequency (RF) module for EPSON
®
TM printers.
This manual provides instructions, including a simple setup for operators of
POS systems in which the UB-R02 is installed so that the operators can use the
UB-R02 safely and correctly.
Key to Symbol
The symbol in this manual is identified by its level of importance, as defined
below. Read the following carefully before handling the product.
Note:
Notes have important information and useful tips on the operation of your equipment.
Features and Functions
64/128-bit WEP
Protocols: TCP, UDP, ICMP, IP, LP/LPR (for APD), TCP socket port (for
OPOS)
Transfer rate: up to 11 Mbps, depending on operating environment
OPOS, APD support
Part Names
The following view shows the part names of the UB-R02.
Note: This photograph shows the TM-T88III printer with the UB-R02 installed.
DIP Switches
When using this interface board, the interface of the TM printer must be
selected as “parallel” with the appropriate settings. Set the reset signal for pin
31 to “enable,” if you are using a TM printer that has this setting. Refer to the
manual for each TM printer for details.
Drawer kick-out
connector
Push button
Power supply
connector
410462701
Vista de pagina 0
1 2 3 4

Indice de contenidos

Pagina 1 - UB-R02 User’s Manual

1UB-R02 User’s Manual Copyright © Seiko Epson Corporation 2004Printed in China 2004.01IntroductionThe UB-R02 is an interface board on which is inst

Pagina 2 - How to Set Up the UB-R02

2 How to Set Up the UB-R02PreparationPrinting a Status SheetPower on the printer. Wait for a few seconds. Then, hold down the push button on the int

Pagina 3 - RF Module

3EMC Standards AppliedProduct Name: UB-R02Model Name: M195AThe following standards are applied only to the interface boards that are so labeled. (E

Pagina 4 - Australia/New Zealand

4 -Increase the separation between the equipment and receiver.-Connect the equipment into an outlet on a circuit different from that to which the re

Comentarios a estos manuales

Sin comentarios